| Click to Post a New Message!
Page [ 1 ] |
|
|
JD Gator only runs with choke
Gator no power with out, Choking EASY FIX NO PARTS NEEDED
Remove Carb , than remove bowl on bottom take care not to loose the float pin, unscrew jet in center of the float , Drill the Jet With #56 metric = about 46 thousands of an inch, blow clean air thru reinstall and but remove rubber thing on end of air filter housing. this is the right fix and you only need a drill # 56 you can get this in the 115 drill set from harbor freight for $30 with 25% off Coupon or $12 online will get you 6 # 56 bit. PS the brace tube inside the high speed hole on the bottom will only go all the way in if the fat part enters last, if you like to clean it up before butting back in get som acetone and soak it all except the rubber gasket don't it will deform it possibly.
Another more complicated option is to get the right fittings and install and adjustable but no one is exactly straight about what kit, its not the one on top you would need to piece mill the bottom, to make that work and order parts that may fit or may not.
John Deere Creates Problems om purpose I think, PS Take Fine Tooth Hacksaw blade and Saw off nub on low speed idle jet adjustment another epa problem solved in 30 seconds.
Link:  
|
|
Add Photo
Bookmarks: |
|
|
|
JD Gator only runs with choke
No, Main Jet 46-47 thousands Drill it with #56 metric bit slowly and easy, I know this works
|
|
Add Photo
Bookmarks: |
|
|
|
JD Gator only runs with choke
no , your incorrect main jet at the in the float bowl sucks gas and the hole is not large enough to start with , so you drill it 46-47 thousands with #56 metric drill.
This makes the gas match the air coming in higher up in there to match it up, than through away the end rubber outside you air cleaner so as not to choke it any more.
Runs like a champ no too; needed.
Don't get bad if your wrong you probably ment right in your own head but put it down wrong here.
|
|
Add Photo
Bookmarks: |
|
|
|
JD Gator only runs with choke
Drill the jet #56 metric drill , the jet inside the carb bowl, you need no parts just the drill , people don't listen to the correct things in live they always think they need to buy some fix.
Ignorance is no excuse, tired of posting after idiots that wont listen.
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 166633 Filter by Poster: 4 | 19 | 1 | 8 | 5 | 5 | 1 | 3 | 4 | 1 |
|
()
Picture of the Day Coachlarry
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers
|